ECM and Profitec: Set Flow Control When Dialing In Grind Size for Espresso

Where do I set my Flow Control when dialing in grind size? The answer: Open it 1.25 turns from fully closed then dial in your grind size. 1.25 turns gives the stock flow rate on any ECM or Profitec machine equipped with flow control. Learn how to set flow properly and make sure you can fully close the valve. Also covers how to change the closed position of the valve.

---

Calibrating Flow Control - Setting When Dialing in Grind Size

1. Introduction (00:00)
2. Flow Setting when dialing In Grind Size (00:42)
3. Setting Zero Position (01:10)
4. Calibrating Zero/No Flow Position (01:30)